30
3. DISASSEMBLY AND REASSEMBLY
Part name
Evaporator
Fan motor
in freezer
Descriptive PictureHow To Do
The evaporator fan is located in the lower
rear of freezer. This fan circulates cold air in
the freezer.
1. Remove screws(4) located at the four corners
of the fan bracket.
2. Take the fan motor assembly off.
3-21) EVAPORATOR FAN MOTOR IN FREEZER
Part name
Evaporator In
Freezer
Descriptive PictureHow To Do
Evaporator is located in the bottom of
freezer to produce cold air driven across the
evaporator coils.
1. Take off the ductwork in Freezer.
2. Disconnect the wire connector (Heater,
Bimental, and Thermistor).
3. Desolder the inlet and outlet tubes.
5. Remove the evaporator.
4. Bend the suction pipe.
6. Take the same steps to seal the system as
mentioned earlier.
3-22) EVAPORATOR IN FREEZER
When diassembling, make
sure the unit is turned off
Caution
*
Reference (How To Do #4)
Accumulator
Thermistor
Bimetal
Sheath
Heater
suction
pipe
To Next Page
Loading...
