Connect the water line to the refrigerator.
1) Slip the compression nut through the provided
plastic tubing.
2) Tighten the compression nut onto 1/4"
comprression fitting.
@ DO not overtighten the compression nut,
NOTE
• Using Copper Tubing
- Slip the compression nut and ferrule on
copper tubing as shown.
• Using Plastic Tubing
- Insert the molded end of the plastic tubing
into the compression fitting.
3) Tighten the compression nut onto the com-
pression fitting.
4) Turn water on and check for any leakage.
NOTE
Ferrule
Refrigerator
( •
_2_ CompressionNut(1/4")
: (Provided)
CompressionNut(1/4_)
(Purchased)
PlasticTubing
CopperTubing (Purchased)
(Purchased)
IHousehold Water Line]
Water line must be connected t0 drinkable water 0n!y.
Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnect,
Install the water filter.
1) As shown, the fixed cap separates from the refrigerator by rotating
it counterclockwise.
Remove the water filter from the box and put a month indicator
stick on the filter as shown.
Keep the cap(A) in a safe place for recapp rig, when you
NOTE don't use the filter................
2) If the water filter was installed in March, put on the "SEP" sticker.
3) Remove the protective cap then position and insert the
filter as shown.
4) Slowly turn the water filter clockwise 90° to align
the indication mark on the cover, locking the filter in
position. Do not overtighten.
SEPARATION
OF RED CAF
STICKER
(MONTH INDICATION)
_4_, _ COVER FILTER
T_:'-i _:'¢_ ALIGNTHE INDICATIONMARK
121 _WITH LOCK POSITION.
Please check that the indication line aligns with the lock positionl
NOTE
27
To Next Page
Loading...
