INSTALLING AND DISASSEMBLING THE DOOR HANDLE
Installing the Door Handle
1. Match the Handle Locking Tabs installed on the left hand side of the door and
the handle inserts.
2.
Fix the handle by pulling it down or tapping it lightly with a tool like a rubber hammer.
3.
Check whether the locking tabs inside the handle are assembled by pulling it up and down.
Leg
Screw Driver
Leg
Screw Driver
<case 1> <case 2>
When installing, servicing, or cleaning behind the refrigerator, be sure to
pull the unit straight out and push back in straight after nishing.
Also, make sure your oor supports the full-load refrigerator.
Otherwise, it may cause oor damage.
CAUTION
LEVELING THE REFRIGERATOR
If the front of the appliance is slightly higher than the rear, the door can be opened and
closed more easily.
case 1) The appliance tilts down to the left.
•
Turn the left adjusting leg in the direction of the arrow until the appliance is level.
case 2) The appliance tilts down to the right.
•
Turn the right adjusting leg in the direction of the arrow until the appliance is level.
• Please tie up the extra length of the power
cord at the back of the refrigerator so as not
to be touched on the oor preventing the
power cord from being crushed by the rollers
upon relocation.
CAUTION
To Next Page
Loading...
