Samsung SCD-2020 - Image Adjustment Settings

COLOR DOME CAMERA User Guide
26
COLOR DOME CAMERA User Guide
27
Operating Your Camera
IMAGE SETUP
1. V-REV OFF
2. H-REV OFF
3. D-ZOOM OFF
4. FONT COLOR WHITE
5. SHARPNESS ON
6. RETURN
2) Select a desired mode using the Function Setup switch.

•V-REV : You can flip the picture vertically on the screen.

•H-REV : You can flip the picture horizontally on the screen.

• D-ZOOM : You can use a digital zoom of x1 ~ x16.

• FONT COLOR : You can change the OSD font color. (White, Yellow, Green, Red, Blue)

•SHARPNESS : As you increase this value, the picture outline becomes stronger and
clearer. Adjust this value appropriately depending on the sharpness of
the picture.

•RETURN : Select this to save the settings for the IMAGE ADJ menu and to return
to the SPECIAL menu.
•WhentheV-REVorH-REVmodeisenabled,thetextonthescreendoesnotflip.
•Ifyouincreasethe SHARPNESS level too high,thepicturemaybecomedistortedor
noise may appear.
Notes

Monitor : Please change the settings value of video
appropriate to your monitor.
- LCD : Please select this menu item when using an
LCD monitor.
You can change the gamma, PED level and
color gain in the sub menus.
  -CRT : PleaseselectthismenuitemwhenusingaCRT
monitor.
  -USER: Please use this menu item when using a monitor other than standard ones. You
can change the gamma, PED level, and color gain in the sub menus.

CAM TITLE : If you enter a title, the title will appear on the monitor.
1) If the SPECIAL menu screen is displayed, use the Function Setup switch so that the
arrow indicates ‘CAM TITLE’.
2) Set it to ‘ON’ by using the Function Setup
switch.
3) Press the Function Setup switch.
4) Use the Function Setup switch to move
to a desired letter and select the letter by
pressing the Function Setup switch.
Repeat this to enter multiple letters. You
can enter up to 15 letters.
CAMERA TITLE SETUP
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
abcdefghijklm
nopqrstuvwxyz
-.0123456789
CLR POS END
•WhentheCAMTITLEmenuis‘OFF’,notitlewillbedisplayedonthemonitorscreeneven
if you enter one.
•OnlyEnglishisavailableinthismode.
•Ifyoumovethecursorto CLRandpresstheFunctionSetupswitch,all thelettersare
deleted. To edit a letter, change the cursor to the bottom left arrow and press the
FunctionSetupswitch.Movethecursoroverthelettertobeedited,movethecursorto
thelettertobeinsertedandthenpresstheFunctionSetupswitch.
Notes

SYNC : In areas where the supply is at 60Hz(NTSC),
50Hz(PAL), you can synchronize the output
phase of multiple cameras using the power
synchronization function (Line-Lock) without
using a synchronization signal generator.
- INT : Internal Synchronization Type
 -L/L :PowerSynchronizationType,Line-lock
FRONT DOOR
5) Enter a title, move the cursor to ‘POS’ and press
the Function Setup switch. The entered title
appears on the screen. Select the position to
display the title on the screen by using the
Function Setup switch and press the Function
Setup switch. When the position is determined,
select ‘END’ and press the Function Setup
switch to return to the SPECIAL menu.