I ENGLISH
Playback
4, The MEMORYfunction works inboth CAMERA and PLAYER modes.
4, You can mark a point on a tape that you wantto return to following playback.
1. Press the ZERO MEMORYbutton on the remote control during playbackor recording atthe point you wish to returnto.
• The time code is changed to a tape counter that is set to zero memory with the [] 0:0O:00(Zeromemory indicator)
• tt you want to cancel the zero memory function, press the ZERO MEMORY button again.
2. Finding the zero position.
• When you have finished playback,fast forward or rewind the tape.
- The tape stops automaticallywhen it reaches the zero position.
• When you have finished recording, press the power switch on the PLAYER and press the 44 (REW) button.
- The tape stops automaticallywhen it reaches the zero position.
3. The tape counter withthe [] (Zero memory indicator)disappears from the display and the tape counter is
changed to the time code.
• In the following situations, ZERO MEMORY mode may be canceled automatically:
- At the end of the section marked with the ZERO MEMORYfunction.
- When the tape is ejected.
- When you remove the battery pack or powersupply.
• The zero memory may not function correctly where there is a break between recordings on the tape.
,,&
To Next Page
Loading...
