Samsung SDH-P4080 - Setting the Ptz

52_ main menu
main menu
Setting the PTZ
To use Camera’s PTZ functions, ID and protocols of each camera and DVR should be matched.
For other settings, refer to the <Remote Devices> settings. (Page 56)
Using the mouse may help make setup easier.
1. Use the up/down buttons (▲▼) in <Device> window to
move to <Camera>, and press [ENTER] button.
2. Select <PTZ>.
A window of PTZ settings appears.
3. Use direction buttons (▲▼_ +) to move to a desired item,
and select i
t.
•I
D : Set the ID of the connected camera of each channel.
You can easily setup by using the numeric buttons on the
remote control.
•Protocol : Set the protocol of the connected camera of each
channel.
M
` You can check the camera’s ID and protocol if you turn the camera off and on after connecting it to the DVR.
4. W
hen the PTZ setup is done, press <OK>.
CH ID Protocol
1 0
>
None

2 1
>
None

3 2
>
None

4 3
>
None

5 4
>
None

6 5
>
None

7 6
>
None

8 7
>
None

Camera
PTZ
Camera
Previous/Next Page
OK Cancel