Samsung SND-5084R - Ethernet Connection

installation & connection
42_ installation & connection
J
`
The CVBS out terminal of the product is provided for easier installation, and is not recommended
for monitoring purposes.
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply (SND-5084R)
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
`
If both PoE and DC 12V are applied simultaneously, the product will be supplied with power from
PoE.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE 802.3af protocols.
- It is advisable to use only one power source from PoE and DC 12V.
`
Be careful not to reverse the polarity when you connect the power cable.
`
If you want to connect an external device, you must turn off the external device before proceeding.
<SNV-5084R>
AC 24V / DC 12V
RESET
VID EO
F
W
AF
T
N
+ -
Monitor to
install
CAUT ION: Be war e of t he
Rate d Volt age an d Pola rity
of t he po wer co nnecti on.
Ethernet
Power