English _51
●
NETWORK CONNECTION AND SETUP
CONNECTING THE CAMERA DIRECTLY TO A PPPoE
MODEM
1. Connect the user PC directly with the network camera.
2. Run the IP Installer and change the IP address of the camera so that you can use
the web browser on your desktop to connect to the Internet.
3. Use the Internet browser to connect to the web viewer.
4. Move to [Setup] page.
5. Move to [Network] – [DDNS] and configure the DDNS settings.
6. Move to [Basic] – [IP & Port] Setup Page, set the IP type to [PPPoE], and enter the
network service’s ID and password.
7. Connect the camera, which was removed from your PC, directly to the modem.
8. Restart the camera.
M
`
For configuring the DDNS settings, refer to “DDNS”. (page 96)
`
For registering the DDNS settings, refer to “Registering with DDNS”. (page 97)
`
Refer to “IP & Port” for how to setup IP. (page 85)
NETWORK
ACT LINK
FRONT
To Next Page
Loading...
