setup screen
48_ setup screen
WDR Setup
It displays a sharp image of the objects in a scene where both bright and dark areas exist.
1. Select <Backlight>.
2. Set <Mode> to <WDR>.
3. Specify the <WDR level>.
M
WDR is available only if <Megapixel
Mode> is set to <2-Megapixel>.
If WDR mode is active, the shutter mode
cannot be changed. Data transfer via the
network is available at up to 15 fps.
If the WDR mode is active, a moving object can cause an afterimage on the screen.
Exposure Setup
You can adjust the exposure level of the camera.
1. Select <Exposure>.
2. Select each item and set it properly.
• Brightness : Adjust the screen
brightness.
• Shutter mode : Adjust the electronic
shutter of the camera.
- ESC (Electronic shutter control) :
Adjust the shutter speed
automatically according to the
ambient brightness.
- Manual : Adjust the shutter speed of the camera manually.
You can select one between 1/30 and 1/12000sec in 2 mega mode, and select one between
1/21 and 1/12000sec in 3 mega mode.
- A.FLK (Anti flicker) : This will prevent the screen from flickering.
• Shutter speed : Control the shutter speed manually.
• SSNR3 : Specify the use of noise reduction.
• SSNR3 level : Adjust the noise reduction level.
To Next Page
Loading...
