installation & connection
16_ installation & connection
Connecting to the monitor
Use the BNC cable to connect the video output port of the camera with the video input
port of the monitor.
M
In the initial installation of the camera, you can connect the camera to the monitor for checking
the connection status.
You can set the video output type to either NTSC or PAL. (page 44).
J
The BNC Out terminal of the product is provided for easier installation, and is not recommended
for monitoring purposes.
If you keep the BNC cable connected, a risk of lightening may cause damage or malfunction to
the product.
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
If both PoE and DC 12V are supplied, the product will operate with the first-applied power source.
If using PoE and DC 12V, the heater will not operate at all.
The heater will operate properly only by the power source of AC 24V. The adaptor is sold
separately.
AC 24V can be applied in non-polarity.
Use AC 24V in a low-temperature place of less than -10°C.
Please make sure the monitor and camera are turned off when connecting them.
To Next Page
Loading...
