setup screen
58_ setup screen
Installing the certificate
1.
Enter the certificate name.
2.
Select the certificate file to be installed and certificate key, and click [Install ( )]
button.
Deleting the certificate
1. Click [Delete ( )] button.
2. To delete a public certificate, you should access the network video decoder in
the mode of <HTTP (Do not use secure connection)> or <HTTPS (Secure
Connection mode using a unique certificate)>.
802.1x
When connecting network, you can choose whether using 802.1x protocol, and then install
the certification.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <802.1x>.
3. Set the <IEEE 802.1x Setting(EAPOL
using EAP-TLS)>.
• Enable IEEE 802.1x : Specify the use
of the 802.1x protocol.
• EAPOL Version : Select version 1 or 2.
• EAPOL ID : Enter the EAPOL ID.
• EAPOL Password : Enter the EAPOL password.
J
If the connected network device does not support the 802.1x protocol, the protocol will not
operate properly even if you set it.
To install/remove 802.1x related certificates
1. Press the [Browse ( )] button for each item and select a certificate to install.
2. If no certificate is installed, you will see “Not Available” appearing next to the selected
item.
3. Press the [Install (
)] button to start installation with a message of “Installed”
next to the item.
4. Press the [Delete ( )] button to remove the certificate.
To Next Page
Loading...
