20_ installation
installation
6. When the installation of additional HDDs is done,
connect the power cable and connect the HDD
signal cables (SATA Cable) to connectors ~
on the main board.
You can check the HDD map directly on the DVR.
Refer to “Storage Device > HDD Map”. (Page 50)
Note that the order the HDD data cable is connected will
not affect the operation. The only consideration is the
length of each cable.
If adding HDDs to
SRD-830D/830DC/850D/850DC/870D/870DC/1610D/
1610DC/1630D/1630DC/1650D/1650DC/1670D/1670DC
The following figures are based on Model SRD-1670D.
1. First, loosen the screws on both sides and remove
the cover.
2. Disconnect the power and HDD Signal cable from
the existing HDDs, then loosen the screws (x4) in
the left/right and upper sides and remove the upper
brackets.
Upper Bracket
Lower Bracket
Cover
To Next Page
Loading...
