English _21
INSTALLATION
3. Install a HDD (x1) on the lower bracket and fix it
with screws.
4. Install HDDs (x3) on the upper bracket and fix them
with screws.
5. When the installation of additional HDDs is done,
insert the lower and upper brackets into the DVR
and fix them with the provided screws.
6. When the installation of additional HDDs is done,
connect the power cable and connect the HDD
data cables (SATA Cable) to connectors ~ on
the main board.
Note that the number of a HDD data calbe is nothing to do
with operation of the HDD. Just make arrangements of the
connectors considering the length of each connector.
7. Check if the connectors are properly connected
and there is no problem with wiring, and close the
cover and fix it with screws.
Upper Bracket
Lower Bracket
Cover
To Next Page
Loading...
