Copyright© 1995-2012 SAMSUNG. All rights reserved. 3-193-19
Disassembly and reassembly
CAUTION
!
3. Lubricating with HANARL: Others components
Apply the HANARL to the Inside and outside friction surface of the components such as ZOOMRING,
CAM BARREL, GUIDE PLATE as illustrated in image below.
■
Make sure to shake the HANARL well rst before you use it until there are no lumps.
■
Apply the HANARL with a clean and good-quality brush, making sure the surface is clean.
■
HANARL is volatile product. Keep its container tightly covered.
BARREL-OUTER CAM
BARREL-BASE
Fig. 3-32
Inside surface
thoroughly
Inside surface
thoroughly
Around the outside
friction surface
To Next Page
Loading...
