Samsung ST200F - Punt ADJ

Adjustment
7-6 Copyright© 1995-2012 SAMSUNG. All rights reserved.
7-5 Punt ADJ
■ Adjustment objective: After replacing the MAIN PCB and BARREL, you must decide the AF search range so that the optimal
focus can be identied by the body tube.
■ Necessary equipment: Innity Collimator
<Adjustment method>
1. Save the adjustment le to the memory card and install it on the camera.
2. Refer to the following adjustment environment specication to adjust the focus.
1) Used specication of Innity Collimator
- Set the illuminance specication of the Collimator to 6 LV.
- Maintain distance of less than 1cm between the end of the camera body tube to the lens surface of the Innity Collimator.
- The camera must be xed while the adjustment is made.
Fig. 7-4
Innity Collimator
Camera
Tripod