Samsung ST200F - 7 Adjustment; Basic Guide for Adjustment

Copyright© 1995-2012 SAMSUNG. All rights reserved. 7-1
Adjustment
7. Adjustment
■ After replacing an electronic part, you must make changes for each adjustment item in the ST200/ST200F.
■ The following table shows the necessary adjustment item for replacing each part.
■ The camera must be xed with a tripod and levelled condition must be maintained.
1. After replacing an electronic part, you must make adjustments for each item by referring to the following table.
<Table. 7-1 Adjustment information>
2. Adjustment equipment
- AE TESTER: AE TESTER that enables LV 12.
- The colour temperature specication of the Light box is 5500K.
- Innity Collimator for PUNT adjustment
- Gray chart (18%) for FLASH & AWB, DARK BOX)
- POWER SUPPLY: 4.2V/2A
3. Adjustment program le
Save and use the program for each adjustment item on the memory card to adjust each item.
The le name for each adjustment item is the same as “ST200_ADJ.TXT”, “ST200F_ADJ.TXT”.
7-1 Basic guide for adjustment
MAIN PCB TOP PCB BARREL ASSY CCD ASSY
FIRMWARE UPGRADE O X O O
LENS SHADING ADJ O X O O
SHUTTER CLOSE TIME ADJ O X O O
FLASH ADJ O O O O
PUNT ADJ O O O O
VERTICAL LINE ADJ O X O O
CCD DEFECT PIXEL ADJ O X O O
OIS CENTERING O X O O
SERIAL NUMBER WRITING ADJ O X X X