Samsung ST200F - Shutter Close Time ADJ

Adjustment
7-4 Copyright© 1995-2012 SAMSUNG. All rights reserved.
7-3 Shutter close time ADJ
■ Adjust the Close timing of the device shutter by camera.
■ Because there is a deviation of shutter closing time by each set, make adjustments by each set to reduce this deviation.
■ CCD Gain item and AWB LOW are adjusted simultaneously.
<Adjustment method>
1. Prepare the AE TESTER that can be adjusted to LV 12.
2. Install the camera to the AE TESTER.
* Luminance specication of the Light box is LV 12.
* The colour temperature specication of the Light box is 5500K.
3. After inserting the memory card containing the program le to the camera, turn on the power of the camera.
4. The adjustment process will automatically start.
q Refer to the specication (Illuminance) for testing.
-Line delay and Sub delay are adjusted so that the appropriate value can be identied to the specication illuminance.
w If the result line delay wish within the min and max range, it is OK. If it is outside of the range, process as NG.
e Refer to the EEPROM WRITE information and write the adjustment result to EEPROM.
r Refer to the CARD WRITE INFORMATION to write the adjustment result to the data le.
5. When the adjustment is completed, the camera will automatically be turned off.
<Adjustment result>
On the memory card, open and check if a CSV le was generated from the adjustment.
<Restriction>
If the capacity of CSV le is more than 30KB, clear all of the previous data and then, record
Fig. 7-2
Light source box
Tripod
Light source box
Camera