SAMSUNG 4-3
Firmware update
4-3 Upgrade
♦ How to execute the rmware
The rmware is congured in the following structure.
Code area is where the execution codes to operate the camera are located, and the Partition [1:3] area is where the various resources
necessary to operate the camera are saved. Among these areas, Partition 3 area is where the Defective Pixel adjustment data and
Lens Shading adjustment data are saved.
User Area is where the setting values are saved through the menu when the user uses the camera, and the adjusted data through
integrated process is saved.
► Reference of general version:
- As the version to update the Code + Partition [1:2] area, this protects both the adjusted data saved in the User Area and
the Partition 3 area.
1. Insert the SD card containing the rmware data le and Upgrade Script le into the camera.
* You need two les to upgrade the FW and the required les are FW data le and Upgrade Script le.
* Because all data saved on the FLASH memory will be reset when you upgrade the rmware, back up
your data before proceeding with the upgrade.
2. Use the AC adaptor or fully charged batteries for the power.
* You can proceed with the upgrade only when the battery level is full (Icon showing full up to 3rd level).
3. Turn on the power of the camera.
code partition1 partition2 partition3 User Area
<Table 4-1>
Fig. 4-6
Fig. 4-7
4. The version of the FW to upgrade will be displayed on the LCD screen. When you press the SHUTTER button,
the FW upgrade will start.
Power ON
To Next Page
Loading...
