Adjustment
5-10 SAMSUNG
5-8 B/T Level ADJ
<Adjustment method>
1. Prepare the POWER SUPPLY.
2. Use the battery jig to connec the POWER SUPPLY to the camera.
3. Set to voltage of 3V.
4. Save the applicable adjustment le to the microSD
TM
card.
5. After inserting the microSD
TM
card containing the program le, turn on the power of the camera.
6. The adjustment will automatically start. This is not displayed on the screen.
qExecute A/D Conversion of the current power supply condition.
wAfter the A/D conversion value of the current power supply voltage is measured, check whether it falls
within the error range. (Idle mode)
[Min A/D conversion value] <= [A/D conversion value of power supply voltage] <= [Max A/D conversion value]
eRefer to the warning and prohibition label to execute the check.
rRefer to the EEPROM WRITE information and write the adjustment result to EEPROM.
tRefer to the CARD WRITE INFORMATION to write the adjustment result to the data le.
7. When the adjustment is completed, the camera will automatically be turned off.
■ Adjust the level of reference voltage to display the battery condition by each camera.
5-9 CCD Defect ADJ
<Adjustment method>
1. Save the applicable adjustment le to the microSD
TM
card.
2. After inserting the microSD
TM
card containing the program le, turn on the power of the camera.
3. The adjustment will automatically start.
q
Check the set reference level, exposure time and loop, and execute the Defective Pixel calibration.
w
Refer to the specication (Maximum number of defective cells) and execute the check.
e
Refer to the CARD WRITE information to write the number of defective cells to the data le.
4. When the adjustment is completed, the camera will automatically be turned off.
<Adjustment result>
Open and check the CSV le generated from the adjustment memory card.
■ Calibrate the Defective pixel of CCD for each camera.
To Next Page
Loading...
