Samsung SVR-1670 - 3.5 Remote Monitoring and Control

Digital Video Recorder SVR-1670
30
Digital Video Recorder SVR-1670
31
Chapter 3. Hardware Installation
You can connect an eSATA external hard disk drive and a USB memory device to the SVR-1670.
To extend the storage capacity of the HDD, you may connect an eSATA external storage device to
the eSATA port on the back of the SVR-1670. The eSATA port supports our SVS-5R eSATA external
hard disk drive.
(External USB hard disk is not supported.)
Connecting an eSATA Device
Turn off the SVR-1670 before you connect an external device to it.
External storage connections
1. After you turn off the SVR-1670, use the eSATA port on the back panel of the SVR-1670 to
connect an SVS-5R external hard disk drive.
2. Attach a power cord to the drive and connect it to an external power source. If necessary, turn
on the eSATA drive.
3. Turn on the SVR-1670.
Figure 3.4.12 Connecting an eSATA Drive
Figure 3.4.13 External Device Connections
This section describes how to confi gure remote access to the SVR-1670. It contains the following
subsections.
• Internet/Intranet Connection Diagram
• Ethernet Connections
The following example is a wiring diagram for the SVR-1670 to control it remotely over the internet
or intranet.
Internet/Intranet Connection Diagram
Figure 3.5.1 Internet Connection
Ethernet Connections
Follow these steps to connect an Ethernet cable to the SVR-1670 :
1. Turn off the SVR-1670.
2. Connect one end of the Ethernet cable to the SVR-1670 and the other end to a hub or router.
Figure 3.5.2 The Ethernet Connections
3. 5 Remote Monitoring and Control