Samsung SVR-1670 - Page 29

Digital Video Recorder SVR-1670
56
Digital Video Recorder SVR-1670
57
DHCP
Dynamic Host Confi guration Protocol (DHCP) manages host addresses on a
network. DHCP is used on a LAN with a DHCP server installed. If the LAN has a
DHCP server and you have enabled this DHCP option, the DHCP server will allocate
an IP address to the DVR.
IP address
IP Address is used for communication between the DVR and SVM-S1, and is also
used when Web Viewer accesses the DVR. It is available only when Net Mask and
Gateway are set.
Net Mask
Net Mask specifi es a range of IP addresses and enables IP addresses in the range
to communicate. Net Mask should be allocated by a network administrator.
Gateway
Gateway must be specifi ed to enable IP addresses to communicate and should be
allocated by a network administrator.
DNS1
DNS1 must be specifi ed to register the DVR to DDNS Server(www.samsungipolis.
com) while DNS Address should be allocated by a network administrator.
Additional DNS Additional DNS is used to replace DNS1 when it is unstable or has a problem.
Port
Port used for connecting to SVM-S1 or Web Viewer. The default port number is
4000.
Bandwidth Limit
(Kbps)
Kbps sets the maximum transmission speed of data output from the DVR (the
data transmission capability of the DVR). This can be left blank. Ask your network
administrator to specify it when necessary.
Setting up for xDSL
This section discusses the options available if your Network Type is xDSL.
Figure 7.1.2 Network Submenu for the Type xDSL (on the Network Setup Menu)
Option Setting
Type
xDSL is the correct setting if the DVR is connected to a PPPoE-type xDSL line.
(If the xDSL line is not of the PPPoE type, you must select Ethernet.)
ID Enter your User ID.
Password Enter your password.
Port
Port is used to register to connect to SVM-S1 or to Web Viewer. The default port is
4000.
Bandwidth Limit
(Kbps)
This sets the maximum transmission speed of data output from the DVR (the
data transmission capability of the DVR). This can be left blank. Ask your network
administrator to specify it when necessary.
Status Displays the connection status of the DVR.
Chapter 7. Communication To/From the DVR