Digital Video Recorder SVR-1670
86
Digital Video Recorder SVR-1670
87
Figure 10.2.1 PTZ Menu
Option Description
P/T
P/T stands for Pan/Tilt. Select this button to operate the Pan or Tilt features of the
camera.
Z/F
Z/F stands for Zoom/Focus. Select this button to operate the Zoom or Focus
features of the camera.
Menu Opens the PTZ menu. To exit the menu, press the PTZ button on the front panel.
Preset
with Load and
Save
You can defi ne where and how you want the camera to position itself.
Aux
with On and Off
Aux stands for Auxiliary, meaning special functions of your particular brand or
model of PTZ camera. For this option, you enter the number that corresponds to
the particular auxiliary function you want to use.
Using Pan/Tilt
Using Zoom/Focus
Loading and Saving Presets
To pan or tilt a camera, select P/T from the PTZ menu.
· To pan the camera, press the left or right arrow key on the front panel, or click the left or right
area of the screen.
· To tilt the camera, press the up or down arrow key on the front panel or click the top or bottom
of the screen.
To zoom or focus a camera, select Z/F from the PTZ menu.
· Use the mouse of the buttons on the front panel to zoom or focus on the image.
A preset is a defi ned camera position; you preset the camera angle and focus.
You must fi rst setup camera preset with PTZ attached to each channel.
To activate a preset location :
1. Go to the PTZ menu.
2. Select a preset number.
3. Select Load and then press the ENTER button.
The camera will pan, tilt or zoom to the specifi cations of that preset condition.
To save a position—in other words, to make it a preset :
1. Pan, tilt and zoom the camera until it adjusted to the position you want to save.
2. Go to the PTZ menu.
3. In the Preset fi eld, select a preset number.
4. Select Save and then press the ENTER button.
Setting Auxiliary Functions
Setting the Console Menu
The Auxiliary feature is used for special functions of a PTZ camera. Specifi c features depend
on the particular make and model of camera you are using. Refer to the manufacturer’s
documentation for information on auxiliary functions.
To use the Auxiliary function :
1. Go to the PTZ menu.
2. To turn on the Auxiliary function, select On.
3. Set up to 16 Auxiliary numbers.
4. To turn off an Auxiliary function, select the Auxiliary number you wish to turn off and select Off.
If the PTZ camera is connected to the DVR with the Samsung SPD protocol, you can confi gure the
camera using its console menu.
To access a camera’s console menu :
1. Use the navigation keys on the front panel to select camera settings.
2. Press ENTER to accept your settings.
Chapter 10. Camera Commands
To Next Page
Loading...
