Install Manual
29
Connection method Insert stripped wire end into terminal block
Pulse width of usable
input
Minimum 500ms
Electric
capacity
Output power Typical DC 12mA
Sensor input terminal connection
Connect sensors to S1 ~ S16 as illustrated in the figure below. Please note that the figure
shows connecting sensors with dry contacts. Refer to the section on handling wiring for more
information about connecting or disconnecting sensor wires.
Sensor Settings
(1) Press [Menu] and select “Event” when the OSD menu appears.
(2) Press [Enter] or [▼] to enter the submenu, select “Sensor” and press [Enter].
To Next Page
Loading...
