HDMI IN 2 (MAGICINFO)
• Connect the [HDMI IN 2 (MAGICINFO)]
terminal at the back of your LCD Display to
the HDMI terminal of your digital output de-
vice using a HDMI cable.
• Up to HDMI 1.3 can be supported.
Note
Using MagicInfo
• To use MagicInfo with an MXn-3, MPn-3
model, connect the MagicInfo output on the
already included network box to [HDMI IN 2
(MAGICINFO)] on the product.
• To use MagicInfo with an MX-3, MP-3 mod-
el, install inside the product a network box
specified by Samsung and connect the Magi-
cInfo output on the network box to [HDMI IN
2 (MAGICINFO)] on the product.
RJ 45 MDC (MDC PORT)
MDC(Multiple Display Control) Program Port
Connect the LAN cable to [RJ45 MDC] on the
product and LAN on the PC. To use an MDC, the
MDC Program must be installed on the PC.
Note
Go to Multi Control and select RJ45 MDC as
the MDC Connection.
RS232C OUT/IN (RS232C Serial PORT)
MDC(Multiple Display Control) Program Port
Connect a serial cable (cross type) to [RS232C]
on the product and RS232C on the PC. To use an
MDC, the MDC Program must be installed on the
PC.
Note
Go to Multi Control and select RS232C MDC
as the MDC Connection.
Applicable to the MXn-3, MPn-3 model only
Introduction
To Next Page
Loading...
