PowerSaver
This LCD
Display has a built-in power management system called PowerSaver. This system saves
energy by switching your LCD Display to low-power mode when it has not been used for a certain
amount of time. The LCD Display automatically returns to normal operation when you press a key on
the keyboard. For energy conservation, turn your LCD Display OFF when it is not needed, or when
leaving it unattended for long periods. The PowerSaver system operates with a VESA DPM compliant
video card installed in your computer. Use the software utility installed on your computer to set up this
feature.
PowerSaverd
State
Normal Op-
eration
Power saving
mode
Power off Power off
(Power
Swich)
Power Indicator On Blinking Amber Off
Power Con-
sumption
(Typical)
400MX-3,
400FP-3
(With Net-
work Box)
250 Watts 5 Watts 5 Watts 0 Watts
400MX-3,
400FP-3
(Without Net-
work Box)
193 Watts 2 Watts 1 Watts 0 Watts
460MX-3,
460FP-3
(With Net-
work Box)
313 Watts 5 Watts 5 Watts 0 Watts
460MX-3,
460FP-3
(Without Net-
work Box)
233 Watts 2 Watts 1 Watts 0 Watts
Note
• The actual
power consumption may be different from the indicated power consumption above if
the system conditions or settings are changed.
• To stop any power consumption, turn off the switch or disconnect the power cable on the back. Be
sure to disconnect the power if you intend to stay away from home for many hours.
• If you connect a network box (sold separately), the product will no longer be in compliance with
Energy Star 5.0 specifications.
Preset Timing Modes
If the signal transferred from the computer is the same as the following Preset Timing Modes, the
screen will be adjusted automatically. However, if the signal differs, the screen may go blank while
the power LED is on. Refer to the video card manual and adjusts the screen as follows.
Specifications
To Next Page
Loading...
