Satellite System (for TD310ES model)
Satellite System is available when Antenna is set to Satellite. Before running Auto Tuning, set Satellite System. Then
channel scan is run normally.
• Satellite Selection: You can choose the satellites for this TV.
• LNB Power (Off / On): Enables or disables the power supply for the LNB.
• LNB Settings: Configures the outdoor equipment.
– Satellite: Selects the satellite for receiving digital broadcasts.
– Transponder: Selects a transponder from the list or adds a new transponder.
– DiSEqC Mode: Selects DiSEqC mode for the selected LNB.
– Lower LNB Oscillators: Sets the LNB oscillators to a lower frequency.
– Upper LNB Oscillators: Sets the LNB oscillators to a higher frequency.
– Tone 22 kHz (Off / On / Auto): Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it
should be Auto.
– Signal Quality: Display the current status of broadcasting signal.
• Positioner Settings: Configures the antenna positioner.
Positioner (On / Off): Enables or disables the positioned control.
Positioner Type (USALS / DiSEqC 1.2): Sets the positioned type between DiSEqC 1.2 and USALS(Universal Satellite
Automatic Location System).
– My Longitude: Sets the longitude for my location.
– My Latitude: Sets the latitude for my location.
– Satellite Longitude Settings: Sets the longitude of user defined satellites.
User Mode: Sets the position of satellite antenna according to each satellite. If you store the current position of
satellite antenna according to a certain satellite, when the signal of that satellite is needed, the satellite antenna can
be moved to pre-populated position.
– Satellite: Selects the satellite to set the position for.
– Transponder: Selects a transponder from the list for signal reception.
– Moving Mode: Selects the movement mode between discrete and continuous movement.
– Step Size: Adjusts the step size degrees for the antenna rotation. Step Size is available when Moving Mode is
set to Step.
– Go To Stored Position: Rotates the antenna to the stored satellite position.
– Aerial Position: Rotate the aerial and store position for this satellite.
– Store Current Position: Stores current position as the selected positioner limit.
– Signal Quality: Display the current status of broadcasting signal.
English - 48
To Next Page
Loading...
