Using the Sleep Timer
MENU → System → Time → Sleep Timer → ENTERE
• Sleep Timer: Automatically shuts off the TV after a preset period of time. (30, 60, 90, 120, 150 and 180 minutes)
✎
Use the ▲/▼ buttons to select a period of time, and then press ENTERE. To cancel the Sleep Timer, select
Off.
Setting the On / Off Timer
MENU → System → Time → On Timer <or> Off Timer → ENTERE
• On Timer: You can set up three separate On Timer configurations. (On Timer 1, On Timer 2, On Timer 3)
Setup: Select Off, Once, Everyday, Mon~Fri, Mon~Sat, Sat~Sun or Manual to set at your convenience. If you select
Manual, you can set up the day you want to activate the timer.
The c mark indicates the day you’ve selected.
Time: Set the hour and minute.
Volume: Set the desired volume level.
Source: To select the source of the content that will play when the TV turns on. You can:
– Select TV and have the TV display a specific Terrestrial or cable channel.
– Select USB and have the TV play back photo or audio files from a USB device.
– Select a source on your TV (HDMI1, HDMI2/DVI, AV, Component, etc.) that you have connected a set-top box
to, and have the TV display a channel from the set-top box.
✎
The USB device must be connected to your TV before you can select USB.
✎
If you select a source other than TV or USB, you must:
• Have a cable or satellite set-top box attached to that source
• Set the set-top box to the channel you want to watch when the TV goes on
• Leave the set-top box turned on.
English - 54
To Next Page
Loading...
