23
Attaching the Stand (U32H850UM*)
―
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
―
The exterior may differ depending on the product.
1 2
3
4
Insert the stand neck into the stand base in the
direction shown in the figure.
Check that the stand neck is firmly connected. Tightly fasten the connecting screw at the bottom
of the stand base.
Place the protective Styrofoam (cushion) included
in the package on the floor and place the product
facing down on the Styrofoam, as shown in the
image.
If Styrofoam is unavailable, use a thick sitting mat.
5
6 7
Place the stand neck of the display on the device
as per the positions of the fasteners.
Turn the stand neck of the display clockwise for
90° to ensure that the stand neck of the display is
put into place.
Install the COVER-REAR SUB after the power
supply and the data cable are connected.
- Caution
Do not press down on the monitor. There is a risk
of damaging the monitor.
To Next Page
Loading...
