76
DisplayPort daisy chain
Select how you want to connect your devices.
•
Clone / Expand
―
Connection
―
On all monitors connected through Loopout, set DisplayPort daisy chain to either Clone or Expand.
(Do not use Clone and Expand together.)
―
After changing the setting on all the monitors that are connected, connect the computer to the primary monitor.
―
To change the DisplayPort daisy chain setting, disconnect the computer from the primary monitor, then change the
setting on all the connected monitors.
Reboot the computer, then connect it to the primary monitor.
If you changed the setting without disconnecting the computer, reboot the primary monitor and then reboot the
connected computer.
―
Requirements for the MST function
―
The UHD (3860 x 2160) resolution is only supported when DisplayPort daisy chain is set to Expand.
Other resolutions are not supported.
―
Windows 7 is recommended.
To Next Page
