Samsung UH55F-E

68
Standby Control
You can set the screen standby mode to be applied when an input signal is received.
 Auto
Power-saving mode will activate if no input signals are detected even though a source
device is connected to the display.
The message No Signal will appear if no source device is connected.
 Off
The message No Signal will appear if no input signals are detected.

If No Signal is displayed although a source device is connected, check the cable
connection.

If No Signal Message is set to Off, the No Signal message does not appear.
If this is the case, set No Signal Message to On.
 On
Power-saving mode will activate if no input signals are detected.
Network Standby
This feature keeps the network power on when the product turns off.
 Off / On
Power Button
The power button can be set to either turn on the power or turn on/off the power.
 Power On Only: Set the power button to turn on the power.
 Power On/Off: Set the power button to turn on/off the power.
Eco Solution
MENU mSystem Eco SolutionENTER E
Energy Saving
Reduce the power consumption by adjusting the screen brightness.
 Off / Low / Medium / High
Eco Sensor
To enhance your power savings, the picture settings will automatically adapt to the light in the
room.
 Off / On

Adjusting the Backlight setting under Picture while Eco Sensor is on will disable the Off.

If the screen contrast is not sufficient, set the Eco Sensor to Off. If the Eco Sensor is Off, it
may not comply with energy standards.
Min. Backlight
When Eco Sensor is On, you can manually adjust the minimum screen brightness. Min.
Backlight is the darkest backlight mode. Make sure the Min. Backlight setting is lower than
the Backlight setting.

If Eco Sensor is On, the display brightness may change (become slightly darker or brighter)
depending on the surrounding light intensity.