Samsung UN43TU7000F - Page 31

3-7
3. Disassembly and Reassemble
Description & Screws Picture Description
10
Before remove ASSY PCB MAIN,
Discharge Capacitors
2CNT
Before remove 3in1 board, Must discharge
capacitors for your safety.
Check discharge point(1st, 2nd block) and then,
discharge with discharge-Jig.
Service Jig-Capacitor Discharge
• If LED ON £ LED OFF discharge is
completed.
BN81-16292A
<Before discharging> <After discharging>
LED ON LED OFF
9 Then verify voltage is less than 10Vdc across
leads with Volt Meter.
Measurement point
Measurement point