4-3-3. PANEL
Status LEDs (1)
Status LEDs (2)
If Noisy Video:1.
Soc T-CON Pattern in Factory Mode 9
Use type of Noise observed (Bars, single lines, video distortion, etc to help.)•
If noise is only on one half of screen check / swap panel cables.•
Verify Defective Panel Cables, TV Main Board or Panel.•
If No Video & Back Lights are OK (on):2.
Check Status LEDs -
If only one is lit replace TV Main Board -
If both are o also check SMPS 13Vdc supplies to Board. -
To Next Page
Loading...
