Samsung VC240

| 26
RADVISION | RADVISION Port Security Reference Guide
SCOPIA XT Desktop Server
Table 1-17 lists ports that need to be open on SCOPIA XT Desktop Server.
Table 1-18 lists the ports on the SCOPIA Desktop XT Server when connected to the public internet.
Table 1-17 Ports supported by SCOPIA Desktop XT Server and Internal Network
Port Range Protocol Direction Severity Functionality
80 TCP Incoming Optional GUI—The alternative is to configure the GUI to run on port
443.
443 TCP Incoming Mandatory Control connection between the
SCOPIA XT Desktop Client
and the
SCOPIA XT Desktop Server.
3336, 3337 TCP Outgoing Mandatory Cascade/XML control connections between SCOPIA
Desktop Server and SCOPIA XT1000.
1025-65535
(configure
within this
range)
TCP Both Mandatory H.323 traffic between the
SCOPIA Desktop Server and the
SCOPIA XT1000 Series.
To edit this range:
1. Navigate to C:\Program Files\Radvision\SCOPIA
Desktop\ConfSrv.
2. Edit the file config.val.
3. Locate the [1 system] section.
At the bottom of that section, add two lines:
2 portFrom = <lowest range limt> and
2 portTo = <highest range limit>.
10000-65535
(configure
within this
range)
UDP Both Recommended Media connection between the SCOPIA Desktop XT Server
and Client. If not open, the connection will be tunneled
via TCP port 443 and performance will not be optimal.
At full capacity, the SCOPIA XT1009 requires 76 ports.
Limit the range of the of the multimedia ports in the
SCOPIA Desktop XT Server Administrator web interface by
naviagting to Client > Settings tab > Multimedia Ports.
Table 1-18 Ports to and from the SCOPIA Desktop XT Server connected to the public internet
Port Range Protocol Direction Severity Functionality
80 TCP Incoming Mandatory GUI access. The alternative is to configure the GUI to run on
port 443.
443 TCP Incoming Mandatory Control connection between the
SCOPIA Desktop Client and
SCOPIA Desktop XT Server.