What to do if my Samsung WA400PJHDWR/AA Washer is leaking water?
If your Samsung Washer is leaking water, it could be due to a couple of reasons. First, check the connections of the air hose, as leakage can occur during the spin cycle if it's out of place. Second, ensure the connecting hose to the detergent drawer is correctly connected. In both cases, check the connections.
What to do if my Samsung WA400PJHDWR/AA Washer has a drain error?
If your Samsung Washer displays a drain error, it could be due to a clogged drain hose. Make sure to clear the drain hose. Also, check the water pump connections to ensure the water pump terminal is connected correctly.
Why does my Samsung WA400PJHDWR/AA show an unbalance error?
If your Samsung Washer displays an unbalance error, it is likely due to the laundry load. Find the reason for the imbalance and solve it as directed in the user manual.
What to do if my Samsung Washer shows a Door Error?
If your Samsung Washer displays a Door Error, the water level sensor terminal might be out of place. Inspect the MEMS sensor and PBA, and also check the wire connector terminals.
What to do if my Samsung WA400PJHDWR/AA Washer has Overflow Error?
If your Samsung Washer shows an Overflow Error, it means water is being supplied continuously because the water level detection isn't working properly. Check whether the drain hose is clogged.
How to fix Temperature Sensor Error on Samsung Washer?
A Temperature Sensor Error on your Samsung Washer indicates an issue with the washing heater in the tub, such as a contact error or temperature sensor fault. To fix this, check the heater sensor and wire connections.
What does Foaming Detected mean on my Samsung WA400PJHDWR/AA Washer?
If your Samsung Washer displays 'Foaming Detected', it means the washer has detected too much foam. This is a normal operation to prevent non-sensing faults.
How to fix Communication Error on Samsung Washer?
A Communication Error on your Samsung Washer means the signals between the sub and main PBAs are not being sensed. To resolve this, carefully check the connector connections between the sub and main PBAs.
How to fix MEMS error on Samsung WA400PJHDWR/AA Washer?
A MEMS error on your Samsung Washer indicates that the output from the MEMS sensor is over 4.5V or under 0.5V. Check the MEMS sensor.
What to do if my Samsung WA400PJHDWR/AA shows Switch Error (Main Relay Error)?
If your Samsung Washer displays a Switch Error (Main Relay Error), it means the Power button is continually pressed. Release the Power button.
Safety guidelines for service engineers during product operation and maintenance.
Detailed overview of the washing machine's key features and technologies.
General| Type | Top Load |
|---|---|
| Capacity | 4.0 cu. ft. |
| Color | White |
| Width | 27 inches |
| Spin Speed | 700 RPM |
| Number of Wash Cycles | 9 |
| Energy Star Qualified | Yes |
| Water Levels | 5 |
| Dispenser | Yes |
| Voltage | 120V |
To Next Page