What to do if my Samsung Washer is leaking water?
If your Samsung Washer is leaking water, it could be due to a couple of reasons. First, check the connections of the air hose, as leakage can occur during the spin cycle if it's out of place. Second, ensure the connecting hose to the detergent drawer is correctly connected. In both cases, check the connections.
What to do if my Samsung WA422PRHDWR/AA has a drain error?
If your Samsung Washer displays a drain error, it could be due to a clogged drain hose. Make sure to clear the drain hose. Also, check the water pump connections to ensure the water pump terminal is connected correctly.
Why does my Samsung WA422PRHDWR/AA show an unbalance error?
If your Samsung Washer displays an unbalance error, it is likely due to the laundry load. Find the reason for the imbalance and solve it as directed in the user manual.
What to do if my Samsung WA422PRHDWR/AA Washer shows a Door Error?
If your Samsung Washer displays a Door Error, the water level sensor terminal might be out of place. Inspect the MEMS sensor and PBA, and also check the wire connector terminals.
What to do if my Samsung WA422PRHDWR/AA has Overflow Error?
If your Samsung Washer shows an Overflow Error, it means water is being supplied continuously because the water level detection isn't working properly. Check whether the drain hose is clogged.
How to fix Temperature Sensor Error on Samsung WA422PRHDWR/AA?
A Temperature Sensor Error on your Samsung Washer indicates an issue with the washing heater in the tub, such as a contact error or temperature sensor fault. To fix this, check the heater sensor and wire connections.
What does Foaming Detected mean on my Samsung WA422PRHDWR/AA?
If your Samsung Washer displays 'Foaming Detected', it means the washer has detected too much foam. This is a normal operation to prevent non-sensing faults.
How to fix Communication Error on Samsung WA422PRHDWR/AA Washer?
A Communication Error on your Samsung Washer means the signals between the sub and main PBAs are not being sensed. To resolve this, carefully check the connector connections between the sub and main PBAs.
How to fix MEMS error on Samsung Washer?
A MEMS error on your Samsung Washer indicates that the output from the MEMS sensor is over 4.5V or under 0.5V. Check the MEMS sensor.
What to do if my Samsung Washer shows Switch Error (Main Relay Error)?
If your Samsung Washer displays a Switch Error (Main Relay Error), it means the Power button is continually pressed. Release the Power button.
Instructions for operating the product safely and preventing accidents during servicing.
Highlights important warnings to be observed while servicing the washing machine.
Emphasizes cautions to be taken before performing washing machine servicing.
Safety precautions to follow after the washing machine servicing is completed.
Lists essential tools required for disassembling and reassembling the washing machine components.
Step-by-step guide for disassembling the control panel, sub PCB, and main PCB assembly.
Instructions for safely removing and disconnecting the water valve housing and its connected hoses.
Steps to remove the door assembly, including inlay tapes and lid screws.
Lists common error codes displayed by the washer and their potential causes.
Provides specific corrective actions for troubleshooting common error modes like Water Level Sensor and Motor errors.
General| Capacity | 4.2 cu. ft. |
|---|---|
| Energy Star Certified | Yes |
| Weight | 130 lbs |
| Color | White |
| Control Type | Electronic |
| Steam Function | No |
| Width | 27 inches |
To Next Page
