Samsung WA48H7400AW/A2 - Page 15

Disassembly and Reassembly _ 13
Part Figure Description
Top Cover Assembly
/ Door Switch
1. Remove the 2 screws from the cover
plate.
2. Separate the control panel assembly.
3. SeparatetheAssyValveWater,themain
PBA,theAssySensorPressureandthe
lterEMIhousing.
Separate the housing to prevent
stress and damage to the wire-
harness.
4. Separatethemainwireharness,the
pressureswitchhoseclip,Grounding
screw .
5. Release the bleach hose clamp.
6. Separate the top cover assembly by
lifting and pushing ahead the top part of
the assembly.
7. youcancheckthedoorswitchIfturnthe
Top cover upside down.
Sensor Pressure
Switch
1. Disassemble the control panel assembly.
2. Separate the pressure switch housing.
3. Beforeseparatingthehose,releasethe
clip.
 Whenreleasingtheclip,takecare
that you do not tear the hose.