Samsung WA5451ANW/XAA - Basic Location Requirements

10 _ Disassembly and Reassembly
3-2. STANDARD DISASSEMBLY DRAWINGS
► Thisisastandarddisassemblydiagramandmaydifferfromtheactualproduct.
Use this material as a reference when disassembling and reassembling the product.
Part Figure Description
Sub and Main PCB
Assembly
1. Remove the 6 screws holding the control
panel assembly.
2. Separatethebothhooks.(LeftandRight)
3. Separate the cover panel upward.
 Ifitisdifculttodisassemble,usethe(-)
drivertodisassemblehooks.
(Becarefuldamageofhooks.)
4. Remove the 2 screws holding the control
panel assembly and turn the panel over.
5. Pull the Encoder-Knob to separate it and
thenremovethe4xingscrews.
 WhenreassemblingthePCB,takecare
that you do not damage the control-panel
xinghook.AfterreplacingthesubPCB,
checkthekeyoperation.
6. Separate the cover pcb(m) and the wires
connected to the main PBA.
 Afterreassemblingthehousing,check
if the wires are properly connected.
When disassembling and reassembling
thehousing,takecarethatyoudonot
damage the part.
Hudson Washer.indb 10 2012-03-28 �� 9:45:51