Troubleshooting _ 21
4-2. CORRECTIVE ACTIONS FOR EACH ERROR CODE
► Thesearecommontroubleshootingproceduresforeachdrum-typewashererrormode.Fordetailedinformation,refertothegeneralrepairscripts.
Error Type
Error
Mode
Causes Corrective Actions Description of Photo
Display
Water Level
Sensor
• Waterlevelsensorfault
• Incorrectconnectionsofthewater
level sensor terminal
• Thehosepartforthewaterlevel
sensor is folded.
• MainPCBfault
• Checkthewaterlevelsensorterminalconnections
and contacts.
• Anerroroccursifanincorrectwaterlevelsensor
isused.Makesuretocheckthematerialcode.
(Abnormal operation)
• Ifthewaterlevelsensorisfaulty,replaceit.
• Iftheerrorpersistsdespitetakingtheactionabove,
replace the PBA.
► Checkthewaterlevelsensor
frequency.
1. Checkitafterthewaterlevel
sensor and the connector are
connected.
CheckingPart:Blue
Color Wire Oragne Color
Wire
2. Frequency:Approx.26.4KHz
without water (Min 25.9KHz)
Washing Motor
Error and Hall
Sensor Error
· Washing motor fault
· Washing motor hall
sensor fault
· Incorrect connections of
the washing motor/hall
sensor connector
· Washing motor rotor
and stator fault
· Main PCB fault
•Checkthemotorconnectorterminal
connections and contacts.
•3Eisdisplayedbecauseoverloading
occurs due to too much laundry.
•Ifthehallsensorterminalisfaulty,
replace the hall sensor.
•Checkwhetherthestatorofthe
motor cover is damaged.
•Checkforcoildisconnectionsdueto
foreign material.
•IfthePBAcontrolcircuitisfaulty,
replace the PBA.
► CheckthemotorWinding
Coil
•Plugouttheconnectorand
read resistances at any two of
the three terminals on Motor
:Shouldbe19.3Ω(at25
o
C)
CN1
1-5V-1
2-Hall-A
3-Hall-B
4-GND
5-Clutch Hall IC
► CheckthemotorHallSensor
• Checktheresistanceonthe
main PCB motor
(Betweenpins2and4,3and4
of the four (4) pins)
-Resistance:Approx.2to4
MΩ
-Checkthevoltagewhenthe
power is on.
Hudson Washer.indb 21 2012-03-28 �� 9:45:57