Samsung WA5451ANW/XAA - Cycle Selector Guide

Troubleshooting _ 19
4. TROUBLESHOOTING
4-1. ERROR MODES
► This is a washer integrated error mode. For detailed information, refer to the general repair scripts.
Error Type Display Causes Remarks
Water Level
Sensor
- The part of the hose where the water level sensor is
located is damaged. (punctured)
- The hose is clogged with foreign material.
- The hose is folded.
- Too much lubricant has been applied to the insertion
part of the air hose.
- Hose engagement error (disengaged)
- Part fault (Faulty internal soldering)
- The water level sensor terminal is disengaged.
- Main PBA fault.
Motor Driving
Error and Hall
Sensor Error
- The PBA connector terminal is not connected.
- The motor spin net is not engaged.
- Themotor’sinternalcoilisdamaged(short-circuited
or cut)
- The hall sensor terminal is not connected.
- Foreign material (e.g. a screw) has entered the motor.
This error occurs because of restrained
revolutions.
Water Supply
Error
- Foreign material is entering the water supply valve.
- The water supply valve terminal is not connected.
(Wire disconnected)
- The warm water and rinse connectors are incorrectly
switched with each other.
- This occurs if the PCB terminal from the drain hose to
thedetergentdrawerisnotconnected.Checkwhether
the transparent hose is folded or torn.
- The cold and warm water supply hoses are incorrectly
switched with each other.
The water supplied for 1 minute drying
cycle is 0.3 ~ 0.4 L.
- Thewatertemperatureissensedashigherthan50˚C
in the Wool or Delicates/Hand wash for 8 seconds
Drain Error
- The pump motor impeller is damaged internally.
- Wrongvoltage(220V→110V)issuppliedtothe
parts.
- Part fault.
- This occurs due to freezing in the winter season
- The drain hose is clogged.
(Injectionerror,foreignmaterial)
- The water pump terminal is not connected: rubber
band,bills,cotton,hairpins,coinshavecollected
inside the drain pump ASSY.
Commnication
Error
- The signals between the sub and main PBAs are not
sensed because of commuication error.
- Checktheconnectorconnectionsbetweenthesub
and main PBAs carefully.
→Checkforincorrectorlooseconnections,etc.
- RemovethesubPBAC/Panelandcheckforany
faulty soldering.
Switch Error
(Main Relay
Error)
- The Power button is pressed continually. (for more
than 12 seconds)
- Aswitchisjammedorstuckduetobepressed
unevenly due to deformation of the control panel or
button.
- This error may occur when the screws that hold the
sub PBA in place are tightened too much.
- A button other than the Power button is continually
pressed. (for more than 30 seconds).
- Deformation of an internal plastic injection part.
- A screw for assembling the sub PBA is tightened too
much.
Hudson Washer.indb 19 2012-03-28 �� 9:45:56