Disassembly and Reassembly _ 15
Part Figure Description
Clutch Assembly
(continued)
1. Separate the top cover assembly by
lifting and pushing ahead the top part of
the assembly
2. Remove the 2 screws holding the panel
control Separate all the wires connected
to the housing.
3. Removethe8screwsxingthetub-
cover and separate the tub-cover.
4. Separate the pulsator-cap by inserting
the tip of a (-) screwdriver between the
pulsator-cap and the pulsator and then
liftingthescrewdriverup(↑).
5. Remove the bolt holding the pulsator
with a 10mm wrench.
Hudson Washer.indb 15 2012-03-28 �� 9:45:54
To Next Page
Loading...
