Samsung WA90F4 - Control Panel Overview

10_setting up your washer
setting up your washer_11
CONTROL PANEL
For more details, see control panel of your washing machine.
POWER BUTTON Press this button once to operate. Press it again to turn the power off.
START/PAUSE
BUTTON
Use to pause and restart the operation. To change the washing procedure
during an operation, press this button to stop, and again to restart after
changing the procedure.
PROGRAM
SELECT BUTTON
Each time the button is pressed, the washing program changes;
Fuzzy  blanket  wool  quick  soak  clean tub
FILTER CHECK
When the wash is finished, the warning lamp lights up on the filter check.
When the door is opened, it turns off. (This is not a fault.) When the Magic
filter is clogged, foreign materials may start sticking to the laundry. To ensure
a clean wash, please remove foreign materials from the filter after every wash.
CHILD-LOCK
FUNCTION
This is a device to protect children from being accidentally hurt while playing
with the washer.
• How to start the Child-Lock function:
- Press the “Power” button to go to an initial washing mode.
- By pressing “Start/Pause” button, you start washing and in case Child
Lock function is needed during the laundry
- Press both the “Water Level” and “Function” buttons at the same
times.(for 3 seconds)
(Note: You cannot perform the function without the “Power” button on.)
• To release the function of Child-Lock: In case the “Child-Lock” is
programmed, press both the “Water Level” and “Function” buttons at
the same time.
REMAINING TIME,
DELAY START TIME,
ERROR DISPLAY
Displays the remaining wash time. Displays the reserved delay start time.
Displays the error state if a problem occurs in the washing machine so that
you can take action.
AIR TURBO
BUTTON
Press this button to speed dry your laundry.
This function can only be selected if a spin cycle is set.
You can add this function to all program except for the Wool program.
FUNCTION
BUTTON
With every press of this button, the function changes;
Wash,Rinse,Spin  Wash  Rinse  Spin  Wash&Rinse  Rinse&Spin
 Wash,Rinse,Spin
WATER LEVEL
BUTTON
The water level is automatically adjusted. However, you can select the water
level manually by pressing this button.
Mid  High  Mid  Low  Extra low  Low  Mid
WATER SUPPLY
BUTTON
Each time this button is pressed, the type of water is selected as follows,
Cold  Cold + Hot  Hot  Cold
setting up your washer
3
2
1
78 6 4910 5
7
6
5
4
3
2
1
10
9
8
WA90F4-02723G-02_EN.indd 10 2012-06-01 �� 6:50:50