setting up your washer
SOAK PROGRAM
Select this function when you wish to wash your laundry by soaking it.
1. Press the Power button to “On”.
2. Press the Program select button four times
3. Press the START/PAUSE button and put the proper amount of
detergent into tub.
4. Close the lid.
KEEPING THE TUB CLEAN
When using the machine under humid conditions for an extended time, various bacteria from the
air may stick to the tub and form black dirt (fungi), causing damage to the human body. To keep
the tub clean and hygienic at all times, it is recommended reading “CLEAN TUB PROGRAM”
above and using only dedicated or recommended detergents to clean the tub regularly at least
once every one to three months.
CLEAN TUB PROGRAM
Use this program to clean the tub. It will keep the tub clean and sanitary.
1. Press the Power button to “On”.
2. Press the Program select button five times.
3. Press the Start/Pause button.
4. Add a delicated detergent and close the lid
- Never place laundry in the tub when cleaning inside the tub, as this can cause
discoloration or damage to the laundry.
- When doing the laundry after cleaning the tub, you may find some impurities. These are
just detergent residues and impurities after the tub cleaning. Perform the rinse cycle two
to three times.
- The Soak function (20 minutes) is set automatically.
- The water level is set to Mid early on and then changed to High during the rinse.
WA90F4-02723G-02_EN.indd 12 2012-06-01 �� 6:50:51
To Next Page
Loading...
