What to do if the Samsung WD1 T has insufficient water supply?
J
James KramerSep 1, 2025
If your Samsung Washer isn't getting enough water, start by fully opening the water tap. Ensure the washer door is completely closed. Check that the water supply hose isn't frozen, kinked, or clogged. Verify that you have sufficient water pressure. Confirm that both the cold and hot water taps are properly connected. Finally, clean the mesh filter, as it may be clogged and restricting water flow.
J
Jeremy JohnsonSep 12, 2025
How to reduce suds in Samsung WD1 T Washer?
P
Phyllis BarnesSep 12, 2025
If you observe excessive suds in your Samsung Washer, use the recommended types of detergent as appropriate, and use high-efficiency (HE) detergent to prevent oversudsing. Reduce the detergent amount for soft water, small loads, or lightly soiled loads. Non-HE detergent is not recommended.
S
Scott MaldonadoAug 30, 2025
What to do if the Samsung WD1 T door does not open?
E
erinboyerAug 30, 2025
If the door of your Samsung washer won't open, tap the start/pause button to stop the machine. It may take a few moments for the door lock to disengage. The door will not open until 3 minutes after the washer has stopped or the power has been off. Ensure all water is drained from the drum. The door lock light should be off after the washer has drained.
J
jasminegraySep 15, 2025
Why can't I add detergent to my Samsung Washer?
M
Mark WilsonSep 15, 2025
If you cannot add additional detergent to your Samsung Washer, make sure the remaining amount of detergent and fabric softener is not over the limit.
M
Makayla MurphySep 14, 2025
What does dispenser open message mean on Samsung Washer?
K
Kathleen AdamsSep 14, 2025
If a message appears on the display of your Samsung Washer alerting that the dispenser is open, check if the detergent drawer is closed properly. Open the detergent drawer and close it again, making sure it’s closed properly.
J
Jay McculloughSep 18, 2025
Why detergent remains in the drawer after Samsung Washer cycle?
P
Paul RamosSep 18, 2025
If detergent remains in the drawer after a Samsung Washer cycle, ensure the washer is running with sufficient water pressure. Make sure the detergent is added to the center of the drawer and that the rinse cap is inserted properly. If using granular detergent, ensure the detergent selector is in the upper position. Remove the rinse cap and clean the detergent drawer.
F
Frank ClarkSep 23, 2025
How to fix detergent remaining in the drawer of my Samsung Washer after a cycle?
K
karen75Sep 23, 2025
If detergent remains in the detergent drawer of your Samsung Washer after a cycle, consider these solutions:
* Ensure the washing machine is running with sufficient water pressure.
* Make sure the detergent is added to the center of the detergent drawer.
* Verify the rinse cap is inserted properly.
* If using granular detergent, ensure the detergent selector is in the upper position.
* Remove the rinse cap and clean the detergent drawer.
J
josephduncanAug 27, 2025
Why is my Samsung WD1 T leaking water?
J
Jason MillerAug 27, 2025
If your Samsung Washer leaks water, ensure the door is properly closed and all hose connections are tight. Verify the drain hose is correctly inserted and secured to the drain system, and that it's not placed on the floor or clogged. Avoid overloading the machine and use high-efficiency (HE) detergent to prevent oversudsing.
N
Nicole Shaw DDSAug 26, 2025
What to do if Samsung Washer does not drain or spin?
B
Barbara GarciaAug 26, 2025
If your Samsung Washer doesn't drain or spin, ensure the drain hose is straightened and not frozen or clogged. Make sure the debris filter is not clogged. Close the door and tap and hold. Also, ensure the drain hose is connected to a drain system that is not clogged and is positioned correctly, depending on the connection type. If the washing machine is not supplied with sufficient power, the washing machine will temporarily not drain or spin. As soon as the washing machine regains sufficient power, it will operate normally. If you encounter a drain problem, call for service.
N
Nicole HahnAug 25, 2025
How to fix Samsung WD1 T that does not start?
J
Julie WilliamsonAug 26, 2025
If your Samsung Washer doesn't start, ensure it's plugged in, the door is properly closed, and the water taps are open. Tap and hold to start the washing machine. Also, verify that Child Lock is not activated. Check the fuse or reset the circuit breaker, and confirm that power is supplied properly. If the low voltage was detected, check if the power cord is plugged in. Ensure laundry isn't caught in the door. If the AddWash door is open, close it properly and tap and hold to resume operation.
To Next Page
General
