Why does my Samsung Washer have odors?
To address odors in your Samsung Washer: * Recognize that excessive suds can collect in recesses and cause foul odors. * Run cleansing cycles periodically to sanitize the machine. * Clean the door seal (diaphragm). * Dry the washing machine interior after each cycle.
Why does my Samsung WD8 T4 Washer keep stopping?
If your Samsung Washer stops during a cycle, ensure the power cord is plugged into a live electrical outlet. Check the fuse or reset the circuit breaker. Close the door and press Start/Pause to start the washing machine, as it won't tumble or spin unless the door is closed properly. Note that before filling, the machine will make clicking noises to check the door lock and perform a quick drain. There may be a pause or soak period in the cycle; wait briefly to see if the machine restarts. Also, ensure the mesh filter of the water supply hose at the water taps isn't clogged. If the washer isn't getting sufficient power, it may temporarily halt; it will operate normally once sufficient power is restored.
Why does my Samsung WD8 T4 Washer fill with the wrong water temperature?
If your Samsung Washer fills with the wrong water temperature, fully open both the hot and cold water taps. Ensure that the temperature selection on the machine is correct and that the hoses are connected to the correct taps. Flush the water lines. Make sure your water heater is set to supply a minimum of 49 °C hot water at the tap, and check its capacity and recovery rate. Disconnect the hoses and clean the mesh filter, as it may be clogged. Note that the water temperature may change as the automatic temperature control feature checks the incoming water temperature, and you might notice only hot or cold water going through the dispenser when cold or warm temperatures are selected.
Why is my Samsung Washer excessively vibrating or making noise?
If your Samsung Washer is vibrating excessively or making unusual noises, ensure it's installed on a level, solid floor that isn't slippery. Remove the shipping bolts if you haven't already. Make sure the washer isn't touching any other objects. Ensure the laundry load is balanced inside the drum. Keep in mind that the motor can create noise during normal operation. Also, items like overalls or clothes with metallic decorations can cause noise, as can metal objects like coins left in the drum or filter case. If you're washing only one or two items, redistribute the load to prevent an unbalanced condition.
Why is the water supply insufficient in my Samsung Washer?
If your Samsung Washer isn't getting enough water, or no water at all, consider the following: * Fully open the water tap. * Ensure the door is properly closed. * Check that the water supply hose isn't frozen, kinked, or clogged. * Make sure there's sufficient water pressure. * Verify that the cold and hot water taps are correctly connected. * Clean the mesh filter, as it may be clogged.
How to fix a Samsung WD8 T4 Washer that does not start?
If your Samsung Washer doesn't start, there are several things to check. First, ensure the washing machine is properly plugged in, the door is securely closed, and the water taps are fully open. Press the Start/Pause button to initiate the cycle. Also, verify that the Child Lock feature is not activated. Before the washer begins to fill, it will make clicking sounds to check the door lock and perform a quick drain. Check the fuse or circuit breaker and ensure power is being supplied correctly. If low voltage is detected, make sure the power cord is plugged in properly. Finally, ensure that no laundry is caught in the door.
Why is my laundry still wet after Samsung WD8 T4 Washer cycle?
If your laundry is still wet after a Samsung Washer cycle, try using the High or Extra High spin speed. Use high-efficiency (HE) detergent to reduce oversudsing. Small loads (one or two items) may become unbalanced and not spin completely. Ensure the drain hose is not kinked or clogged.
Why my Samsung Washer suddenly stops?
If your Samsung Washer stops unexpectedly, ensure the power cord is plugged into a live outlet and check the fuse or circuit breaker. Close the door and tap start to resume. Note that the washer clicks and does a quick drain before filling. There might be a pause or soak period in the cycle. Also, check the mesh filter of the water supply hose for clogs. If power is insufficient, the washer will temporarily stop until power is restored.
How to reduce vibration of Samsung WD8 T4 Washer?
Excessive vibration or noise in your Samsung washer can be resolved by ensuring it's installed on a level, solid, non-slippery floor; use the leveling feet to adjust the height if needed. Make sure the shipping bolts are removed and that the washer isn't touching any other object. Ensure the laundry load is balanced. Note that the motor can cause noise during normal operation. Remove any metal objects from the drum or filter case after washing and redistribute the load.
How to fix Samsung Washer with insufficient water supply?
To address insufficient water supply in your Samsung Washer, fully open the water tap. Ensure the door is properly closed. Check that the water supply hose is not frozen, kinked, or clogged. Verify sufficient water pressure. Ensure the cold and hot water taps are correctly connected. Clean the mesh filter, as it may be clogged.
General| Washing Capacity | 8 kg |
|---|---|
| Spin Speed | 1400 rpm |
| Color | White |
| Digital Inverter Motor | Yes |
| Eco Bubble Technology | Yes |
| AddWash Door | Yes |
| Quick Wash | Yes |
| Delay Start | Yes |
| Child Lock | Yes |
| Dimensions (HxWxD) | 85 cm x 60 cm x 60 cm |
| Programs | Cotton, Synthetics, Wool, Delicate |
To Next Page