32
Part Name Descriptive Picture How To Do
③
Tilt the unit backward and take out the
drain pump.
④
Disconnect the incoming water hose and
thewireharness.
(Caution: Check if th e unit is plugged out.
There is possibility of electric sho ck.)
⑤
SeparatetheHoseFilterTubandtheDrain
Hose.
※
CHECK POINT
1. Remove the Drain Filter and check if there are foreign substances (coin, buttons, e tc)
blocking inside - If so, clea r the inside.
2. Check if the wire harness is connected properly - If not , connect it properly.
3. If water leaks, check if the Clamp Hose and the Cap Drain are assembled tightly
- If not, assemble them tightly.
Remove the water remaining inside by turning the Filter counter clockwise.
To Next Page
Loading...
