installing your washer
STEP 2
Selecting a Location
Before you install your washer, make sure the location:
• Has a hard, level surface
• Is away from dir
ect sunlight
• Has adequate ventilation
• Will not freeze (below 32°F or 0°C)
• Is away from heat sour
ces such as oil or gas
• Has enough space so that your Washer need not stand on its power cor
d
• Doesn’t have any carpeting that will obstruct ventilation openings.
STEP 3
Removing the Shipping Bolts
Before using your Washer, you must remove the four
shipping bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with
the spacer thr
ough the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
STEP 4
Installing your Washer
1. Place the drain hose in the drain facility. Be
sure an airtight connection is NOT made
between the drain hose and the standpipe.
The standpipe must be at least 18 in or 46
cm high.
Caution must always be exercised to
avoid collapsing or damaging the drain
hose. For best results, the drain hose
should not be r
estricted in any way – by
elbows, couplings, or excessive lengths.
For situations where the drain hose
cannot be conveniently elevated to at
least 18 in or 46 cm, the drain hose must
be supported.
96” Max
18” Min
96” Max
18” Min
Hose
r
etainer
Tie strap
Laundry tub Stand pipe
To Next Page
Loading...
