PROBLEM SOLUTION
will not start..
• Make sure the door is firmly closed.
• Make sure your Washer is plugged in.
• Make sur
e the water source faucets ar
e open.
• Make sure to press the Start/Pause Button to start your W
asher.
• Make sure the Child Lock is not activated; see page
14.
• Before your Washer starts to fill, it will make a series of clicking noises
to check the door lock and do a quick drain.
• Check the fuse or reset the circuit br
eaker
has no water or not enough
water..
• Turn both faucets on fully.
• Make sure the door is tightly closed.
• Straighten the water inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be
plugged.
• Open and close the door
, then press the Start/Pause Button.
has detergent r
emains in
the automatic dispenser
after the wash cycle is
complete.
• Make sure your Washer is running with suf
ficient water pressure.
• Make sure the Detergent Selector dial is in the upper position when
using granular detergent.
vibrates or is too noisy.
• Make sure your Washer is set on a level surface. If the surface is not
level, adjust your W
asher feet to level the appliance.
• Make sure that the shipping bolts are r
emoved.
• Make sure your Washer is not touching any other object.
• Make sur
e the laundry load is balanced.
stops
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit br
eaker.
• Close the door and press the Start/Pause Button to start your
Washer
.
For your safety, your Washer will not tumble or spin unless the door is
closed.
• Before your Washer starts to fill, it will make a series of clicking noises
to check the door lock and do a quick drain.
• There may be a pause or soak period in the cycle. Wait briefly and it
may start.
• Check the screens on the inlet hoses at the faucets for obstructions.
Clean the screens periodically.
To Next Page
Loading...
