troubleshooting
fills with the wrong
temperature water.
• Turn both faucets on fully.
• Make sure the temperatur
e selection is correct.
• Make sure the hoses ar
e connected to the correct faucets.
Flush water lines.
• Check the water heater. It should be set to deliver a minimum 120°
F (49° C) hot water at the tap. Also check the water heater capacit
y
and recovery rate.
• Disconnect the hoses and clean the screens. The hose filter scr
eens
may be plugged.
• As your Washer is filling, the water temperatur
e may change as
the automatic temperature control feature checks incoming water
temperature. This is normal.
• While your Washer is filling, you may notice just hot and/or just
cold water going thr
ough the dispenser when cold or warm wash
temperatures are selected. This is a normal function of the automatic
temperature control feature as your Washer determines the
temperature of the water.
door locked or will not
open.
• Press the Start/Pause Button to stop your Washer.
• Your Washer door will remain locked during the heating portion of the
Sanitize Cycle
• It may take a few moments for the door lock mechanism to
disengage.
does not drain and/or spin.
• Check the fuse or reset the cir
cuit breaker.
• Straighten the drain hoses. Eliminate kinked hoses. If there is a drain
r
estriction, call for service.
• Close the door and press the Start/Pause Button. For your safety
,
your Washer will not tumble or spin unless the door is closed.
load is too wet at the end of
the cycle.
• Use the High or Extra High spin speed.
• Use high efficiency detergent to r
educe over–sudsing.
• Load is too small. Very small loads (one or two items) may become
unbalanced and not spin out completely
.
leaks water.
• Make sure the door is firmly closed.
• Make sure all hose connections ar
e tight.
• Make sure the end of the drain hose is corr
ectly inserted and secured
to the drainage system.
• Avoid overloading.
• Use high efficiency detergent to pr
event over–sudsing.
has excessive suds.
• Use high efficiency detergent to pr
event over-sudsing.
• Reduce the detergent amount for soft water, small or lightly soiled
loads.
• Non-HE detergent is NOT recommended.
To Next Page
Loading...
