Water valve connections for the Detergent Drawer
Items Packed With Washer
BOLT-SPANER (10-13mm Wrench) DC60-40146A
ASSY HOSE WATER Cold DC97-15648A
ASSY HOSE WATER Hot DC97-15648B
CAP-FIXER DC67-00307A
HOSE-HANGER DC62-10278A
When using non-HE detergents, or using too much deter-
gent for the water hardness and soil level of the clothing,
over sudsing will occur. When this happens there will be
leaks out of the detergent drawer and door. Please advise
consumer of proper detergent usage.
It is normal for some water remain in the Detergent
Drawer after it completes washing. Bleach is usually
flushed out into the tub at the beginning of the washing.
Also, its compartment is washed again during the follow-
ing rinse cycle, removing any remnants.
To unlock the door if washer is stuck in the door
locked mode.
Remove top, remove console, remove screws for
front panel, pull panel forward.
Picture “A” pull bottom of plastic cover away from
front until it pops off.
Picture “B” pull down on plastic lever to release
lock.
Remove lock ass’y to replace plastic cover.
A
B
SUPPORT INFORMATION
Training — Plus One http://my.plus1solutions.net/clientPortals/samsung/
Help — GSPN http://service.samsungportal.com/
NOTE: Tee
moved to
Main Valve
hose on later
production.
To Next Page
Loading...
