4-10
- Demo mode is entered when the Delay Start + Signal + Extra Wash buttons are held down for ve (5) seconds simultaneously in the power
on state.
- When entering Demo mode, the buzzer rings three (3) times and “- - - -” is displayed on the 8888 segment display and all other LEDs arer
turned off. (Initial Demo mode)
- Demo mode consists of WASH, SPIN and LED modes.
- If the Temp button is pressed during the initial Demo mode, “WASH” blinks on the 8888 segment display and the washing machine enters
WASH mode.
- If the Start/Pause button is pressed in WASH mode, the door is locked (Door Lock) and the motor rotates left and right at 45 RPM in a 7 sec
on and 3-sec off cycle.
- WASH mode continues up to ve (5) minutes once started. After the ve (5) minutes have elapsed, “- - - -” is displayed on the 8888 segment
display and the initial Demo mode is maintained.
- If the Start/Pause button is pressed during a WASH mode operation, “- - - -” is displayed on the 8888 segment display and the initial Demo
mode is maintained.
- If the Spin button is pressed in the initial Demo mode, “Spin” blinks on the 8888 segment display and the washing machine enters SPIN
mode.
- If the Start/Pause button is pressed in the SPIN mode, the door is locked (Door Lock) and a spin is operated at 1280 RPM. When the speed
reaches 0 RPM, the No Spin, Low, Medium, High, and Extra High LEDs are turned on.
- During a spin operation, the No Spin LED turns on when the speed is lower than 400 RPM. The Low LED turns on between 400 RPM and
600 RPM. The Medium LED turns on between 600 RPM and 950 RPM. The High LED turns on between 950 RPM and 11 00 RPM. The High
LED turns on at higher than 11 00 RPM.
- SPIN mode continues up to four (4) minutes once started. After the four (4) minutes have elapsed, “- - - -” is displayed on the 8888 segment
display and the initial Demo mode is maintained.
- If the Start/Pause button is pressed during a SPIN mode operation, “- - - -” is displayed on the 8888 segment display and the initial Demo
mode is maintained.
- If the Silver Care button is pressed during the initial Demo mode, “LED” is displayed on the 8888 segment display and the washing machine
enters LED mode.
- If the Start/Pause button is pressed in LED mode, all LEDs are turned on. The LED mode continues up to thirty (30) seconds once started.
After the thirty (30) seconds have elapsed, “- - - -” is displayed on the 8888 segment display and the initial Demo mode is entered.
- If the Start/Pause button is pressed during an LED mode operation, “- - - -” is displayed on the 8888 segment display and the initial Demo
mode is entered.
4-2-11. Demo Mode
To Next Page
Loading...
